01-10-2015, 11:26 PM
Hello All,
I forgot I had a acct. here. Well it has been about a year since my introduction post. I did not get nearly as many projects done as I would have liked. However I did purchase a kit and Build my First 3D Printer!! A Makerfarm I3V 10"
It has been assembled and in use for a while now. I will try and organize my photos and post them up. The Makerfarm has been good to me, However I would most likely not buy a wood frame based printer again. I have the source Files for the 10" I3V so at some point I may rebuild it with a Acrylic Frame.
Now on to current Projects, I am starting to design my own 3D Printer ( not yet named lol ). My new printer will be of Solid Metal construction. No (or Minimal ) 3D Printed parts and No wood. Not sure How I am going to build it as of yet due to the fact I do not have a cnc router or mill to make the parts. But I shall cross that bridge when I get there.
It will be running Lead Screws and Aluminum Linear Rail. I am building this printer around a 8x8x8 Build Volume. I have also included a 10x10x8 and 12x12x12 build volumes within the design needing very little changed between sizes. It could go larger as well but at that point I would look into a different lead screw assembly.
It functions very similarly to your basic Prusa ( Such as my makerfarm 10″ I3V and should keep my electronics and software simple ) but with no belts and better accuracy and rigidity, It should be a better printer all around.
Here is a photo of the Printer so far. I have not decided on a hotend mount setup yet. Tho I did leave enough room for dual extruders and the E3D V6 Bowden setup has been decided on.
I am thinking of running this printer with the Beaglebone Black with the Replicape and Manga Screen(when available). Just to try something new. However will most likely start with a Ramps setup to get going.
I forgot I had a acct. here. Well it has been about a year since my introduction post. I did not get nearly as many projects done as I would have liked. However I did purchase a kit and Build my First 3D Printer!! A Makerfarm I3V 10"
It has been assembled and in use for a while now. I will try and organize my photos and post them up. The Makerfarm has been good to me, However I would most likely not buy a wood frame based printer again. I have the source Files for the 10" I3V so at some point I may rebuild it with a Acrylic Frame.
Now on to current Projects, I am starting to design my own 3D Printer ( not yet named lol ). My new printer will be of Solid Metal construction. No (or Minimal ) 3D Printed parts and No wood. Not sure How I am going to build it as of yet due to the fact I do not have a cnc router or mill to make the parts. But I shall cross that bridge when I get there.
It will be running Lead Screws and Aluminum Linear Rail. I am building this printer around a 8x8x8 Build Volume. I have also included a 10x10x8 and 12x12x12 build volumes within the design needing very little changed between sizes. It could go larger as well but at that point I would look into a different lead screw assembly.
It functions very similarly to your basic Prusa ( Such as my makerfarm 10″ I3V and should keep my electronics and software simple ) but with no belts and better accuracy and rigidity, It should be a better printer all around.
Here is a photo of the Printer so far. I have not decided on a hotend mount setup yet. Tho I did leave enough room for dual extruders and the E3D V6 Bowden setup has been decided on.
I am thinking of running this printer with the Beaglebone Black with the Replicape and Manga Screen(when available). Just to try something new. However will most likely start with a Ramps setup to get going.