Spokane Create! Forums

http://www.visualnews.com/2015/03/mind-b...the-world/

Stuff like this makes me see the advantage of lasers....

Found something that might be useful for your build plate: http://www.instructables.com/id/Detaille...-Assembly/

Thanks Arthur. Maybe we could try doing this next week if I got the parts.

Look at what 2 minutes of calibration got me . I'm not sure if you seen it or not, but I left 2 of my vases at SC for you to compare to the print quality of your delta!

https://www.dropbox.com/s/fwnr0a668haviq...4.jpg?dl=0

(06-06-2015, 09:28 AM)ctcollins9 Wrote: [ -> ]Look at what 2 minutes of calibration got me . I'm not sure if you seen it or not, but I left 2 of my vases at SC for you to compare to the print quality of your delta!

https://www.dropbox.com/s/fwnr0a668haviq...4.jpg?dl=0

Awesome! Gotta love a dead-on print calibration. Is that build plate nice and level now, too?

I saw, they're actually at my house with the rest of the parts. It's coming together. So far I have 7/12 brackets. Still have 3 carriages and tensioners to print. Getting about 3 prints a day (10 hours). Just about to go setup the CNC to cut the frame plates. I'm hoping I can dial it in as well as yours is and your vases don't remain a point of envy. Then I'll have to send you a vase 16" tall.

Sounds good. Yes, my bed leveling is working perfect with the kossel bed level probe set up. Also, if I wanted to send something to SC, who/where should I send it to?

Per the http://www.SpokaneCreate.org homepage:

EDIT: address changed. Pulled the wrong one from the homepage.

840 E Spokane Falls Blvd
Bay #1
Spokane, WA 99202