Dan, sorry I haven't printed them yet, it has been chaos as we are in the middle of moving out stuff to our new house that is 8 hours away, but I still have access to my printer and will try to get the parts printed soon.....
Again, thanks so much!
Dan, after I have been using the bed leveling system you modeled, I have found it works really really well. I would like to make one change to part 1, can you please make it 1.5mm thicker (total of 4.5mm thick) and for the holes on the edges that fit the bolts, can you please move them out about, say, 3mm on each side. Part 2 is perfect, BTW! I have really been missing SC lately, and there aren't any decent makerspaces near me
.
Sincerely, Colby!
Yikes, time flies
Here you go! give it a go and let me know if I miss understood the directions.
Thank you! I appreciate it a lot! I know you're probably busy!
Edit 9/4/15: I tested the part and it will work perfect. Thanks.