3d printer - Printable Version +- Spokane Create! Forums (http://forum.spokanecreate.org) +-- Forum: Spokane Create! (http://forum.spokanecreate.org/forumdisplay.php?fid=1) +--- Forum: General Discussion (http://forum.spokanecreate.org/forumdisplay.php?fid=2) +--- Thread: 3d printer (/showthread.php?tid=374) |
3d printer - thuan.huynh - 06-17-2016 What is a prefer nominal gap between a heated nozzle and the build plate pad for a 3d printer? RE: 3d printer - ABearden - 06-18-2016 When heated to operating temperature, the gap should be the same as your first layer height (roughly 0.05mm to 0.2mm). Generally, you need to have a way to adjust your Z-endstop to very close and then use software configuration to fine tune it. |