Please visit the homepage for location and information on open hours |
Thread Rating:
Thanks so much!
|
02-19-2015, 09:01 AM,
|
|||
|
|||
Thanks so much!
Hello. This is Colby Collins. I just wanted to say again, thank you guys so much for helping me with my delta 3D printer, even though last night's problem was so simple . It is printing AMAZING at >250mm/s, which is way better than I had expected when I got it. Spokane Create is an amazing group and it is so fun for me to come.
Yours Sincerely, Colby Collins. By the way, everyone who bought one of those micro quadcopers, have tons of fun with it. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Thanks so much! - by ctcollins9 - 02-19-2015, 09:01 AM
RE: Thanks so much! - by ABearden - 02-19-2015, 09:34 AM
RE: Thanks so much! - by ctcollins9 - 02-19-2015, 09:52 AM
RE: Thanks so much! - by ctcollins9 - 02-20-2015, 09:40 AM
RE: Thanks so much! - by ABearden - 02-20-2015, 10:11 AM
RE: Thanks so much! - by ctcollins9 - 02-20-2015, 03:22 PM
RE: Thanks so much! - by ABearden - 02-21-2015, 01:03 AM
RE: Thanks so much! - by ctcollins9 - 02-25-2015, 10:40 AM
RE: Thanks so much! - by ctcollins9 - 03-01-2015, 04:20 PM
RE: Thanks so much! - by n8cutler - 03-04-2015, 02:17 PM
|
Users browsing this thread: 1 Guest(s)