Please visit the homepage for location and information on open hours


Thread Rating:
  • 2 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Laser Engraving on My Kossel Clone/ Expanding My Build Area
03-12-2015, 06:46 AM,
#9
RE: Laser Engraving on My Kossel Clone
I didn't have time to come on Wednesday, seems like every time we have to do something, it is on Wednesday at about 5:00. I should have my hot end next week, and I hope to come in and see what everyone has got going. I am thinking about finding some way to get the magnetic ball joints so I can easily switch between a laser and my hot end. I haven't ordered a laser yet, because I don't know anything about them, so I am waiting till I can talk to someone. I found a heated bed for my printer for a good price ($18) and I would really like to use ABS, but then I would have to come up with a enclosure, and I think that would cost more than it's worth. (I remember last time I tried to print ABS with no enclosure on my TwoUp, it smelled really bad)
Reply


Messages In This Thread
RE: Laser Engraving on My Kossel Clone - by ctcollins9 - 03-12-2015, 06:46 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)