Please visit the homepage for location and information on open hours
Spokane Create! Forums › Spokane Create! › Projects v
Laser Cutter

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Laser Cutter
08-19-2015, 01:00 AM,
#14
ABearden Offline
Moderator
*****
 		Posts: 224
Threads: 23
Joined: Oct 2014
Reputation: 2
RE: Laser Cutter
Did some testing with the newest forced air setup today. Worked great. 0.5mm kerf @ 150mm/min. Pretty sure I can bump that to 180-200. At 250 it wasn't making it through 100%. Not bad for the same power consumption as a lightbulb.


Attached Files Thumbnail(s)
       
Find
Reply


Messages In This Thread
Laser Cutter - by ABearden - 04-19-2015, 02:59 PM
RE: Laser Cutter - by ABearden - 04-21-2015, 08:08 PM
RE: Laser Cutter - by ABearden - 04-27-2015, 07:14 PM
RE: Laser Cutter - by ctcollins9 - 04-28-2015, 06:30 AM
RE: Laser Cutter - by ABearden - 05-03-2015, 10:00 PM
RE: Laser Cutter - by ABearden - 05-13-2015, 03:06 PM
RE: Laser Cutter - by TroyCoon - 05-14-2015, 09:54 AM
RE: Laser Cutter - by ABearden - 05-14-2015, 01:25 PM
RE: Laser Cutter - by ABearden - 05-17-2015, 09:52 PM
RE: Laser Cutter - by ABearden - 05-29-2015, 12:17 AM
RE: Laser Cutter - by ABearden - 05-30-2015, 08:39 PM
RE: Laser Cutter - by n8cutler - 05-31-2015, 08:20 AM
RE: Laser Cutter - by ABearden - 05-31-2015, 09:14 AM
RE: Laser Cutter - by ABearden - 08-19-2015, 01:00 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)