Please visit the homepage for location and information on open hours |
Thread Rating:
Enclosure for Running Belt Electronics
|
06-18-2015, 07:54 PM,
|
|||
|
|||
RE: Enclosure for Running Belt Electronics
(06-17-2015, 11:17 PM)ABearden Wrote: Sounds awesome! And yeah, 3D printing sounds like a good fit. The only thing I would point out is start thinking about print orientation while you're designing it so the layers aren't oriented in a way that weakens the part. Much like wood grain, it'll split fairly easily along the layers. Thanks ABearden for the advice! I'm going to dig out some foam and mock up an enclosure...from there, I'll have the dimensions I'll need to modify the project box file to fit. I'll also try that subtraction feature...I think that would be a nice added bonus! Thanks again for the tips! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Enclosure for Running Belt Electronics - by Brendan - 06-17-2015, 08:38 PM
RE: Enclosure for Running Belt Electronics - by ABearden - 06-17-2015, 11:17 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-18-2015, 07:54 PM
RE: Enclosure for Running Belt Electronics - by Dan - 06-19-2015, 02:30 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-19-2015, 08:54 PM
RE: Enclosure for Running Belt Electronics - by ABearden - 06-20-2015, 12:08 AM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-20-2015, 08:23 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-24-2015, 09:21 PM
|
Users browsing this thread: 1 Guest(s)