Please visit the homepage for location and information on open hours |
Thread Rating:
Enclosure for Running Belt Electronics
|
06-20-2015, 12:08 AM,
|
|||
|
|||
RE: Enclosure for Running Belt Electronics
Instead of screw supports, have you entertained mounting components to a board that slides into extrusion and is held in place by 3D printed endcaps? Could hold the whole thing together with a single screw, and body strength wouldn't be an issue at all. I didn't get a chance to look at the prototype you brought in, so it really depends on how you plan on mounting it.
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Enclosure for Running Belt Electronics - by Brendan - 06-17-2015, 08:38 PM
RE: Enclosure for Running Belt Electronics - by ABearden - 06-17-2015, 11:17 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-18-2015, 07:54 PM
RE: Enclosure for Running Belt Electronics - by Dan - 06-19-2015, 02:30 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-19-2015, 08:54 PM
RE: Enclosure for Running Belt Electronics - by ABearden - 06-20-2015, 12:08 AM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-20-2015, 08:23 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-24-2015, 09:21 PM
|
Users browsing this thread: 1 Guest(s)