Please visit the homepage for location and information on open hours |
Thread Rating:
Enclosure for Running Belt Electronics
|
06-24-2015, 09:21 PM,
|
|||
|
|||
RE: Enclosure for Running Belt Electronics
Success!
Thanks to some great advice (Thanks Arthur) I was able to manipulate the project box to the dimensions I was shooting for. Attached is the Sketchup file, and the STL exports (Binary and Ascii)...is this the format needed for the 3D print? Brendan |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Enclosure for Running Belt Electronics - by Brendan - 06-17-2015, 08:38 PM
RE: Enclosure for Running Belt Electronics - by ABearden - 06-17-2015, 11:17 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-18-2015, 07:54 PM
RE: Enclosure for Running Belt Electronics - by Dan - 06-19-2015, 02:30 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-19-2015, 08:54 PM
RE: Enclosure for Running Belt Electronics - by ABearden - 06-20-2015, 12:08 AM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-20-2015, 08:23 PM
RE: Enclosure for Running Belt Electronics - by Brendan - 06-24-2015, 09:21 PM
|
Users browsing this thread: 1 Guest(s)