|
Please visit the homepage for location and information on open hours |
Thread Rating:
|
Bed Leveling Probe = Epic Fail
|
|
08-23-2015, 05:02 PM,
(This post was last modified: 08-28-2015, 10:42 AM by ctcollins9.)
|
|||
|
|||
|
RE: Bed Leveling Probe = Epic Fail
Dan, after I have been using the bed leveling system you modeled, I have found it works really really well. I would like to make one change to part 1, can you please make it 1.5mm thicker (total of 4.5mm thick) and for the holes on the edges that fit the bolts, can you please move them out about, say, 3mm on each side. Part 2 is perfect, BTW! I have really been missing SC lately, and there aren't any decent makerspaces near me
 . Sincerely, Colby!
"If it isn't broke, fix it until it is"
|
|||
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)