Please visit the homepage for location and information on open hours |
Thread Rating:
3D Printer recommendations
|
09-14-2015, 02:06 PM,
|
|||
|
|||
RE: 3D Printer recommendations
One thing to note: I cannot tell you how much I wish I had used my dremel tool to make all of the screw holes on the plastic parts big enough for the screws to slide through easily.
And, if I were you, I would go ahead and buy a E3D v6 hotend, or a v6 lite, they are very nice and make a big difference in prints, which was a suprise to me.
"If it isn't broke, fix it until it is"
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
3D Printer recommendations - by matelich - 09-10-2015, 10:02 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-10-2015, 11:05 AM
RE: 3D Printer recommendations - by matelich - 09-10-2015, 12:02 PM
RE: 3D Printer recommendations - by ctcollins9 - 09-10-2015, 01:09 PM
RE: 3D Printer recommendations - by ABearden - 09-10-2015, 02:33 PM
RE: 3D Printer recommendations - by matelich - 09-11-2015, 04:21 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-13-2015, 05:49 AM
RE: 3D Printer recommendations - by tupperck - 09-14-2015, 08:36 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-14-2015, 11:08 AM
RE: 3D Printer recommendations - by Gyroman - 09-14-2015, 11:22 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-14-2015, 02:06 PM
RE: 3D Printer recommendations - by Prozach - 10-09-2015, 03:14 PM
|
Users browsing this thread: 1 Guest(s)