Please visit the homepage for location and information on open hours
Spokane Create! Forums › Spokane Create! › Projects v
Die Cast Mold

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Die Cast Mold
09-13-2015, 02:20 PM,
#2
ABearden Offline
Moderator
*****
 		Posts: 224
Threads: 23
Joined: Oct 2014
Reputation: 2
RE: Die Cast Mold
Alignment pegs will help with product quality. Multiple pry gaps along the edges will help with release without messing with the sprue surface. Not having a flat "bottom" (to the right) on the sprue would increase material pressure when pouring. Tapering out the top of the sprue will make starting the pour easier. ...and that's as far as my very limited molding knowledge goes.

Aluminum beads?
Find
Reply


Messages In This Thread
Die Cast Mold - by IdeaMakers - 09-13-2015, 10:27 AM
RE: Die Cast Mold - by ABearden - 09-13-2015, 02:20 PM
RE: Die Cast Mold - by IdeaMakers - 09-14-2015, 06:46 PM
RE: Die Cast Mold - by ABearden - 09-15-2015, 07:37 AM
RE: Die Cast Mold - by IdeaMakers - 09-20-2015, 06:57 AM
RE: Die Cast Mold - by Dan - 09-21-2015, 06:46 AM
RE: Die Cast Mold - by ABearden - 09-20-2015, 10:24 AM
RE: Die Cast Mold - by IdeaMakers - 09-29-2015, 12:00 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)