Please visit the homepage for location and information on open hours
Spokane Create! Forums › Spokane Create! › Projects v
Die Cast Mold

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Die Cast Mold
09-14-2015, 06:46 PM,
#3
IdeaMakers Offline
Administrator
*******
 		Posts: 67
Threads: 16
Joined: Apr 2013
Reputation: 0
RE: Die Cast Mold
Thanks for the suggestions ABearden. I did add some slots for prying the mold open and did have register marks just not shown in the render. Was able to make good progress today, milled the beads out and the channels connecting to the middle pour channel. Started to mill the pour channel also but after two hours and only an 1/8" deep decided I'd give the neighbors a rest. Not sure I can open the pour channel to much more, like to keep a 1/4" of metal between the pour and the outside of the mold at least.

Thanks again, John
John Woj
IdeaMakers Designs, LLC
"I'm on the the verge of something" Breaking Bad
Website Find
Reply


Messages In This Thread
Die Cast Mold - by IdeaMakers - 09-13-2015, 10:27 AM
RE: Die Cast Mold - by ABearden - 09-13-2015, 02:20 PM
RE: Die Cast Mold - by IdeaMakers - 09-14-2015, 06:46 PM
RE: Die Cast Mold - by ABearden - 09-15-2015, 07:37 AM
RE: Die Cast Mold - by IdeaMakers - 09-20-2015, 06:57 AM
RE: Die Cast Mold - by Dan - 09-21-2015, 06:46 AM
RE: Die Cast Mold - by ABearden - 09-20-2015, 10:24 AM
RE: Die Cast Mold - by IdeaMakers - 09-29-2015, 12:00 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)