Please visit the homepage for location and information on open hours |
Thread Rating:
Grbl CNC Router Troubleshooting
|
01-31-2016, 11:36 PM,
|
|||
|
|||
RE: Grbl CNC Router Troubleshooting
Did it previously have 0.8 or earlier on it? The Z-limit pin changes when you move to 0.9, which may cause issues.
Have you checked wire continuity to the Z-motor? A dead/high resistance leg can cause some oddball movements. Have you checked GitHub for any known issues with 0.9j? Are you using a shield? And if so, which one? |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Grbl CNC Router Troubleshooting - by Jeff_W - 01-31-2016, 01:48 PM
RE: Grbl CNC Router Troubleshooting - by ABearden - 01-31-2016, 11:36 PM
RE: Grbl CNC Router Troubleshooting - by IdeaMakers - 02-01-2016, 09:49 AM
RE: Grbl CNC Router Troubleshooting - by Jeff_W - 02-06-2016, 11:37 PM
|
Users browsing this thread: 1 Guest(s)