Please visit the homepage for location and information on open hours |
Thread Rating:
Grbl CNC Router Troubleshooting
|
02-06-2016, 11:37 PM,
|
|||
|
|||
RE: Grbl CNC Router Troubleshooting
Apologies for not getting back to the thread sooner; I thought I had subscribed to it, but apparently failed.
I did resolve the issue (which ended up being a continuity issue- apparently jostled a z-axis connection to the stepper loose from my shield while I was doing the limit switches). @Abearden- Yeah, I had upgraded from 0.8 before doing the limit switch install. I was pulling my hair out for a bit regarding the z-limit pin. I don't navigate github all that well, so I didn't discover the change right away. I'm still tinkering with getting probing to work, but haven't really had a chance to get back to it, yet. I'm going to mill a custom touch plate to use for it at work. Thank you for taking the time to make replies, I do appreciate it. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Grbl CNC Router Troubleshooting - by Jeff_W - 01-31-2016, 01:48 PM
RE: Grbl CNC Router Troubleshooting - by ABearden - 01-31-2016, 11:36 PM
RE: Grbl CNC Router Troubleshooting - by IdeaMakers - 02-01-2016, 09:49 AM
RE: Grbl CNC Router Troubleshooting - by Jeff_W - 02-06-2016, 11:37 PM
|
Users browsing this thread: 1 Guest(s)