Please visit the homepage for location and information on open hours |
Thread Rating:
Printing with the Leapfrog Dual
|
03-17-2016, 06:11 AM,
|
|||
|
|||
RE: Printing with the Leapfrog Dual
Yeah, I think one of the big problems was the Leapfrog software wasn't up to date. With an up to date Slic3r and OctoPrint, it seems to run like a finished product. Disclaimer: I've only printed one thing, but once I got the bed properly leveled it seemed to work fine with PLA.
After I get the OctoPi a case, I'll try ABS again. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Printing with the Leapfrog Dual - by fossum - 03-16-2016, 07:13 PM
RE: Printing with the Leapfrog Dual - by ABearden - 03-16-2016, 10:48 PM
RE: Printing with the Leapfrog Dual - by fossum - 03-17-2016, 06:11 AM
RE: Printing with the Leapfrog Dual - by n8cutler - 03-17-2016, 05:54 PM
RE: Printing with the Leapfrog Dual - by fossum - 03-23-2016, 12:17 PM
RE: Printing with the Leapfrog Dual - by ABearden - 04-13-2016, 09:43 PM
RE: Printing with the Leapfrog Dual - by cobweb - 04-24-2016, 04:41 PM
|
Users browsing this thread: 1 Guest(s)