Please visit the homepage for location and information on open hours
Spokane Create! Forums › Spokane Create! › Projects v
Dry-Erase Plotter

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dry-Erase Plotter
04-28-2016, 11:09 AM,
#3
Brendan Offline
Junior Member
**
 		Posts: 41
Threads: 10
Joined: Jun 2015
Reputation: 0
RE: Dry-Erase Plotter
(04-27-2016, 09:36 PM)ABearden Wrote: I don't know that you can manage sub-$100, but it doesn't have to be expensive. Easiest/cheapest would probably be a RAMPS setup (arduino, shield, drivers) and will start at about $20 on eBay, and NEMA17s start around $10 each. Servo ~$5. Power supply would be cheapish. Nearly any 7+A 12V supply should work. Rails, bearings, and hardware will be more but that depends on your design. Linear bearings are the very expensive way to go; look at the Kossel design (3D printer) to use regular bearings on a carriage for something cheaper.

This is perfect; thanks!

Brendan
Find
Reply


Messages In This Thread
Dry-Erase Plotter - by Brendan - 04-27-2016, 07:18 PM
RE: Dry-Erase Plotter - by ABearden - 04-27-2016, 09:36 PM
RE: Dry-Erase Plotter - by Brendan - 04-28-2016, 11:09 AM
RE: Dry-Erase Plotter - by Dan - 05-02-2016, 03:26 PM
RE: Dry-Erase Plotter - by ABearden - 05-03-2016, 04:51 PM
RE: Dry-Erase Plotter - by TroyCoon - 11-04-2016, 07:42 PM
RE: Dry-Erase Plotter - by ABearden - 11-07-2016, 02:39 PM
RE: Dry-Erase Plotter - by Brendan - 11-09-2016, 06:58 PM
RE: Dry-Erase Plotter - by IdeaMakers - 11-10-2016, 11:59 AM
RE: Dry-Erase Plotter - by Brendan - 11-12-2016, 08:36 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)