Please visit the homepage for location and information on open hours |
Thread Rating:
CNC Routing Guitars
|
02-18-2019, 03:43 PM,
|
|||
|
|||
RE: CNC Routing Guitars
Hey, thanks for the reply.
I'm unsure of the exact difference between 2.5D and 3D; there are contoured edges so my guess would be 3D. Here is a picture for reference: There are also routed cavities on the back, so clearly I'm going to have to run it as two separate processes (front and back) and find a way to line it up perfectly. Any idea on how to do this? It will be either Ash or Alder, I do not have the wood yet. Some videos online show that most of these cuts work well with a 3/8 bit so we should be good on that front. For the smaller stuff I will bring my own bits. I will not be there this Wednesday, but will probably be there the following week. Again, thank you for the help! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
CNC Routing Guitars - by ththomas41 - 02-17-2019, 03:47 PM
RE: CNC Routing Guitars - by Dan - 02-18-2019, 10:24 AM
RE: CNC Routing Guitars - by ththomas41 - 02-18-2019, 03:43 PM
RE: CNC Routing Guitars - by Dan - 02-18-2019, 03:52 PM
|
Users browsing this thread: 1 Guest(s)