Please visit the homepage for location and information on open hours |
Thread Rating:
New Member to this Forum
|
11-23-2020, 06:36 PM,
|
|||
|
|||
RE: New Member to this Forum
(11-23-2020, 09:48 AM)dfosterjr Wrote:(11-21-2020, 02:07 AM)ABearden Wrote: They've made a foundry and tried out some lost-PLA casting. It was a neat project and there were a few people involved so you should be able to get input. I think they got it to eventually. Seemed to be a matter of building the mold properly so any leftover slag floated to the top. If I remember correctly, they did both plaster and green sand. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
New Member to this Forum - by dfosterjr - 11-17-2020, 09:44 AM
RE: New Member to this Forum - by Differential_FaW - 11-20-2020, 11:11 AM
RE: New Member to this Forum - by dfosterjr - 11-20-2020, 11:20 AM
RE: New Member to this Forum - by ABearden - 11-21-2020, 02:07 AM
RE: New Member to this Forum - by dfosterjr - 11-23-2020, 09:48 AM
RE: New Member to this Forum - by ABearden - 11-23-2020, 06:36 PM
RE: New Member to this Forum - by shovel - 11-22-2020, 10:26 PM
RE: New Member to this Forum - by dfosterjr - 11-23-2020, 09:51 AM
|
Users browsing this thread: 1 Guest(s)