Please visit the homepage for location and information on open hours |
Thread Rating:
Looking for Someone to Create a Inkscape/Eggbot project
|
04-24-2021, 09:48 AM,
|
|||
|
|||
RE: Looking for Someone to Create a Inkscape/Eggbot project
Did you go through the setup and tutorial listed in the manual: https://cdn.evilmadscientist.com/KitInst...srevA1.pdf ?
Looks like you raise or lower the motor to set the curve of the object (lower for more oblong and higher for more spherical), and need an 800x3200 Inkscape file to match the rotational resolution of the machine. With the Eggbot plugins for Inkscape, it looks like the setup is physically adjusting the machine and drawing the design in Inkscape. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Looking for Someone to Create a Inkscape/Eggbot project - by kevin0226 - 04-23-2021, 04:10 PM
RE: Looking for Someone to Create a Inkscape/Eggbot project - by ABearden - 04-24-2021, 09:48 AM
|
Users browsing this thread: 1 Guest(s)