Please visit the homepage for location and information on open hours


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Presentation on pcb etching?
05-13-2014, 05:49 PM,
#1
Wink  Presentation on pcb etching?
So I was thinking about doing a presentation on etching pcbs. I'm thinking a simple 555 blinky led circuit. I have designed an ic board with some solder pads. If anyone is interested, I'll bring the supplies either tomorrow or another time. I'm sure I could cover the cost and parts, but help is always appreciated. Everyone would have a circuit to take home when it's over.
Reply
05-14-2014, 12:56 PM,
#2
RE: Presentation on pcb etching?
This is an awesome idea! We will make time for it.
-N8

"I built it because I didn't know I couldn't"
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)