|
Please visit the homepage for location and information on open hours |
Thread Rating:
|
Thanks so much!
|
|
02-19-2015, 09:34 AM,
|
|||
|
|||
|
RE: Thanks so much!
Will say it again, good job on that printer!
This morning I'm looking at Bowden tubes for my MakerFarm. Hopefully that speeds it up a fair bit. Otherwise I might have to disassemble it for something like yours after seeing that output! I can give up flex filament if it means 200+mm/s. If I know people are going to being quads on a regular basis, I'll bring my Hubsan along more often. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Thanks so much! - by ctcollins9 - 02-19-2015, 09:01 AM
RE: Thanks so much! - by ABearden - 02-19-2015, 09:34 AM
RE: Thanks so much! - by ctcollins9 - 02-19-2015, 09:52 AM
RE: Thanks so much! - by ctcollins9 - 02-20-2015, 09:40 AM
RE: Thanks so much! - by ABearden - 02-20-2015, 10:11 AM
RE: Thanks so much! - by ctcollins9 - 02-20-2015, 03:22 PM
RE: Thanks so much! - by ABearden - 02-21-2015, 01:03 AM
RE: Thanks so much! - by ctcollins9 - 02-25-2015, 10:40 AM
RE: Thanks so much! - by ctcollins9 - 03-01-2015, 04:20 PM
RE: Thanks so much! - by n8cutler - 03-04-2015, 02:17 PM
|
Users browsing this thread: 1 Guest(s)