Spokane Create Delta Printer

[ABearden]

This hasn't been abandoned! Just needed to switch gears for a little while since I seriously burned myself out with the run up to the open house and I've been really busy trying to keep work coming in.

Nothing like spending an evening watching Season 3 of Avatar: The Last Airbender while rebuilding a 3D model from vertices. Apparently SolidWorks makes for a dirty STL, but the geometry was too good to throw out and start from scratch. Dropped all of the faces/edges (except the sexy belt ridges), purged the unnecessary vertices, then manually re-stitched the vertices with new faces. Split the carriage into a clamp design and added four bolts that simultaneously pinch the belts and the linear bearings. Also relocated the "ears" to hopefully remove the tilt at the edges of the build plate.

Here's carriage v2.0.