Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create Delta Printer
|
07-22-2015, 10:05 PM,
(This post was last modified: 07-22-2015, 10:10 PM by ABearden.)
|
|||
|
|||
RE: Spokane Create Delta Printer
STLs for the carriages. The test carriage worked well, though I once again had to get Chris' help because unless you have an over abundance of belt it's difficult to clamp it together with two hands.
Still to come: - Other two carriages. - Wiring & routing. - Configuration & measurements. |
|||
08-05-2015, 10:59 AM,
|
|||
|
|||
RE: Spokane Create Delta Printer
"If it isn't broke, fix it until it is"
|
|||
08-19-2015, 10:49 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer
It moves!
Got the firmware updated and the motors plugged in so I got it to move at the Spark event tonight. Now to:
|
|||
09-20-2015, 09:29 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer | |||
09-21-2015, 06:29 AM,
|
|||
|
|||
RE: Spokane Create Delta Printer
Woohoo! Definitely ready for some calibration, but good job!
"If it isn't broke, fix it until it is"
|
|||
09-21-2015, 06:44 AM,
|
|||
|
|||
RE: Spokane Create Delta Printer
NICE!
good job dude!
-Dan
"If you didn't build it, you will never own it." - Barton Dring |
|||
09-21-2015, 10:05 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer
(09-21-2015, 06:29 AM)ctcollins9 Wrote: Woohoo! Definitely ready for some calibration, but good job!Calibrated it today. Extruder steps/mm were 2/3rds of what they needed to be due to the Greg's extruder gearing. I need to level the glass and/or add a z-probe, but it prints pretty nice. Plenty fast too. Just a little bit of rounding on the corners @ 200mm/s due to flex. Going to add some rubber bands on the rods to see if I can control that a little bit. (09-21-2015, 06:44 AM)Dan Wrote: NICE!Thanks, but I definitely didn't solo this build! You did awesome on the CAD and plenty of others helped out with both cost and build (Chris, Nate, & John off the top of my head). Time to print! |
|||
09-22-2015, 07:27 AM,
|
|||
|
|||
RE: Spokane Create Delta Printer
-Dan
"If you didn't build it, you will never own it." - Barton Dring |
|||
09-27-2015, 10:26 AM,
|
|||
|
|||
RE: Spokane Create Delta Printer
Sheesh, we get ours done and someone has to show us up: http://www.digitaltrends.com/cool-tech/w...d-printer/
|
|||
09-27-2015, 11:27 AM,
|
|||
|
|||
RE: Spokane Create Delta Printer
(09-27-2015, 10:26 AM)ABearden Wrote: Sheesh, we get ours done and someone has to show us up: http://www.digitaltrends.com/cool-tech/w...d-printer/ Makes me want to print a huge clay Batman!
-N8
"I built it because I didn't know I couldn't" |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 2 Guest(s)