Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create Delta Printer
|
09-21-2015, 10:05 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer
(09-21-2015, 06:29 AM)ctcollins9 Wrote: Woohoo! Definitely ready for some calibration, but good job!Calibrated it today. Extruder steps/mm were 2/3rds of what they needed to be due to the Greg's extruder gearing. I need to level the glass and/or add a z-probe, but it prints pretty nice. Plenty fast too. Just a little bit of rounding on the corners @ 200mm/s due to flex. Going to add some rubber bands on the rods to see if I can control that a little bit. (09-21-2015, 06:44 AM)Dan Wrote: NICE!Thanks, but I definitely didn't solo this build! You did awesome on the CAD and plenty of others helped out with both cost and build (Chris, Nate, & John off the top of my head). Time to print! |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)