Spokane Create Delta Printer

[ABearden]

Thanks man! I don't know exactly what we need just yet. It will be a lot of custom parts though. At least a dozen of the same part to brace the frame, three motor mounts, three pulley mounts, plate mounts, three carriages, the platform/head, and at least one fan mount but probably two.

I'm PLA only as well until I get my enclosure built. ABS would be awesome for heat resistance, but getting started it's probably not worth the hassle.

Measured bits tonight. The 4' rods are 16mm and the older 5' rods are 14mm. I need to pickup some linear bearings for the older rods.

Other than zipties, misc metric hardware, and frame bits I think this is what I'm looking at (let me know if you find anything missing):
- 24' GT2 belt
- 3x GT2 pulleys
- 6x bearings (opposite end of belts)
- 4' Bowden feed
- 6x Traxxis rods
- 3x 14mm linear bearings

Already on the way or at Create Space:
- RAMPS driver
- Stepper motors
- Roller end stops (good positive contacts, magnetic snap closing)
- JHead hotend
- Greg's extruder driver