Spokane Create Delta Printer

[ABearden]

Lookin' good!

3x 0.5" board + 2x 1.25" brackets/spacers = 4" total for top and bottom.

My thinking on the frame bolts was to add 0.85" tall insets with 0.20" or so flanges top and bottom on the brackets. That way, the M5x30 bolts go through the flange on one bracket, through the board, and through the flange on the second bracket which is 22.86mm total, leaving 7mm for the nut. I think we talked about it about a month ago, but I really should upload more of the drawings. I should be able to squeeze in time this weekend to clarify and upload all the sketches.

Can you export any STLs for the brackets? Just so I can get a rough idea of the filament mass requirements and get a few rolls of filament on the way. I just ordered some this morning because Inventables is liquidating their 3D printing stock, but unfortunately they sold out of all of the $5/roll filament before I found out about it.