Spokane Create Delta Printer

[ABearden]

Looks nice. Two concerns which might be addressed, but can't tell from the picture:
- Will an M3 bolt hold the belt w/o tearing it? (is there something I can't see?)
- The rods need a little room "behind" the ears for the effector heads, but I can't see that side of the carriage.

We can absolutely make the bearings press fit. I was planning on going thick wall anyway, so if a little sanding needs to happen we can do that.

The way the ears are on the stock machine, it's 40mm outside to outside. The bolts point inward through the effector heads, the ears, and then a bolt is inset into the inside of the ear.


And in unrelated, but affects the project, news: my boss just called to tell me they can't keep me fulltime. Wheeee. Probably going on a spending freeze for projects for a while depending on how this plays out.