Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create Delta Printer
|
05-12-2015, 06:51 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer
(05-12-2015, 10:19 AM)ABearden Wrote: Looks nice. Two concerns which might be addressed, but can't tell from the picture: Sorry about the job :-( lame - Do you know how thick those ears are so I can match them? - The carriage has the GT2 tooth profile internal, I was hoping the M3 would provide the pressure on the belt, but the internal teeth would hold it. - Any idea on how far those ears should stick out? (from center hole to bearing carriage)
-Dan
"If you didn't build it, you will never own it." - Barton Dring |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 4 Guest(s)