Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create Delta Printer
|
05-12-2015, 08:00 PM,
(This post was last modified: 05-12-2015, 08:01 PM by ABearden.)
|
|||
|
|||
RE: Spokane Create Delta Printer
(05-12-2015, 02:46 PM)ctcollins9 Wrote: Want a proximity sensor for the delta? Here's one in the US on eBay for $2.59 + $1.93 shipping: http://www.ebay.com/itm/LJ12A3-4-Z-BX-In...3cf5e2e66a. Although, I can't find a mount, but if there is one, it should work for both printers, as the effectors are the same.For bed leveling? Unfortunately that's an inductive proximity sensor which requires metal within 4mm for it to trigger. (05-12-2015, 06:51 PM)Dan Wrote: Sorry about the job :-( lame- The glow-in-the-dark yellow effector platform is in the tub if you want a close look at it. I'll bring in an effector rod head tomorrow. The ears are 14mm wide and 12mm apart for 40mm outside-to-outside. They are 8mm tall. How far they stick out is odd due to the triangular shape of the platform, but it's 10+ mm. I attached the STL in the ZIP below. - Ah, that makes sense. Worst case we can print internal tabs for the M3 to press into and increase the surface area without changing the model much. - I think I had 0.5" for the entire ear, but anything over 6mm from center hole to carriage should work. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 2 Guest(s)