Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create Delta Printer
|
05-12-2015, 08:11 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer
I came up with a novel way to tension the upper pulley (at least in my mind)
Basically this(rendering attached) would sit on top of the linear shafts and hold the pulley (on a free wheeling shaft) then 2 M3's would be used to thread down on top of the linear shafts to lift the whole assembly up. Might look a little goofy since the shafts would have to protrude past the upper most layer
-Dan
"If you didn't build it, you will never own it." - Barton Dring |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 6 Guest(s)