Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create Delta Printer
|
05-31-2015, 12:02 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer
Did a test-fit run of the first quarter inch or so of the frame brackets and the carriage. Nice job Dan!
At 103% (accounting for ABS shrinkage) the bearings are a perfect press fit into the carriage. The frame-to-guide fitment is more like an interference fit, so I might oversize those slightly to 104%. Probably going to need a vice/press/hammer to push everything together. Only thing I need to change is the "return" passage for the belt is too small to let the belt move freely, so I'll open that up for the final prints. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 2 Guest(s)