Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create Delta Printer
|
06-06-2015, 03:11 PM,
|
|||
|
|||
RE: Spokane Create Delta Printer
Looking Good!
Please let me know if you need me to do anything? I was able to print in PLA on the leapfrog machine (you can look at TOOLBOXNW facebook) I tried ABS several times but had a lot of problems, I think the bed was not hot enough. I had read online that it should be 100c but the highest I could get was 87c and that was after several hours of it warming up. it still did not stick to the bed correctly so perhaps you can show me what I need to do to fix that. Just let me know what I can do to help
-Dan
"If you didn't build it, you will never own it." - Barton Dring |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)