Please visit the homepage for location and information on open hours


Thread Rating:
  • 2 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Laser Engraving on My Kossel Clone/ Expanding My Build Area
03-20-2015, 08:07 AM,
#19
RE: Laser Engraving on My Kossel Clone/ Expanding My Build Area
Scale them by the same amount. If your horizontal beams scale up by 50%, scale your rods up by 50% as well. Think of the triangle created by your build plate, your tower, and your traxxas rods; you want to keep that triangle roughly the same ratio when you rebuild (it's not required, but it makes it simple). Your towers don't need to change, but longer rods will decrease your build height with the same size towers. Once you've got the new frame, you'll have to reconfigure your firmware as well so it properly calculates your geometry.
Reply


Messages In This Thread
RE: Laser Engraving on My Kossel Clone/ Expanding My Build Area - by ABearden - 03-20-2015, 08:07 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)