Please visit the homepage for location and information on open hours |
Thread Rating:
Spokane Create's CNC Mill
|
07-07-2015, 07:58 PM,
|
|||
|
|||
RE: Spokane Create's CNC Mill
(07-03-2015, 12:30 AM)ABearden Wrote: Out of curiosity, what's your preferred coolant / cutting fluid? I don't have anything specific in mind. I've used several different types in the past, but KoolMist is the only brand I remember using. I never purchased the stuff, just used it. Basically something general purpose (aluminum and steel) that hopefully doesn't stink to bad, non-corrosive, and can sit for at least a week without use. If we have to do a skimmer setup, we can...but it would be nice to find something that works well without it. Local shops may have a recommendation on what could meet our needs. Or if someone else has more experience with coolant selection I'd love some input.
-N8
"I built it because I didn't know I couldn't" |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Spokane Create's CNC Mill - by n8cutler - 04-28-2015, 09:04 PM
RE: Spokane Create's CNC Mill - by ABearden - 04-28-2015, 10:44 PM
RE: Spokane Create's CNC Mill - by tupperck - 04-29-2015, 05:40 PM
RE: Spokane Create's CNC Mill - by ABearden - 05-07-2015, 08:27 AM
RE: Spokane Create's CNC Mill - by ABearden - 07-01-2015, 08:47 PM
RE: Spokane Create's CNC Mill - by n8cutler - 07-02-2015, 09:15 PM
RE: Spokane Create's CNC Mill - by ABearden - 07-03-2015, 12:30 AM
RE: Spokane Create's CNC Mill - by n8cutler - 07-07-2015, 07:58 PM
|
Users browsing this thread: 1 Guest(s)