Location

213 E Ermina Ave, Spokane WA, 99207

Open Hours

5:30pm - 8:30pm Tuesdays

Note that open hours recently changed from Wednesdays to Tuesdays

Thanks for supporting your
community 501(c)(3) makerspace


Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3D Printer recommendations
09-14-2015, 08:36 AM,
#8
RE: 3D Printer recommendations
(09-13-2015, 05:49 AM)ctcollins9 Wrote: The noise is actually much quieter than that, the microphone on the phone I had at the time that I was recording with was less than crappy. I, myself, am pretty much hooked on deltas by now, especially because of how fast they print. One thing to consider, not that it will stop any maker from getting a printer, they are money pits, at least for me. I originally paid $500 for my printer kit, and now, I have had my printer for about 9-10 months, I have over $850 into it. Good luck, and have fun.

Colby, thanks for the tip. I went ahead and ordered one of these. I was impressed by the quality you acheived on yours. Can you tell me what sort of upgrades you've found most helpful?
Reply


Messages In This Thread
3D Printer recommendations - by matelich - 09-10-2015, 10:02 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-10-2015, 11:05 AM
RE: 3D Printer recommendations - by matelich - 09-10-2015, 12:02 PM
RE: 3D Printer recommendations - by ctcollins9 - 09-10-2015, 01:09 PM
RE: 3D Printer recommendations - by ABearden - 09-10-2015, 02:33 PM
RE: 3D Printer recommendations - by matelich - 09-11-2015, 04:21 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-13-2015, 05:49 AM
RE: 3D Printer recommendations - by tupperck - 09-14-2015, 08:36 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-14-2015, 11:08 AM
RE: 3D Printer recommendations - by Gyroman - 09-14-2015, 11:22 AM
RE: 3D Printer recommendations - by ctcollins9 - 09-14-2015, 02:06 PM
RE: 3D Printer recommendations - by Prozach - 10-09-2015, 03:14 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)