Location

We've moved!
213 E Ermina Ave, Spokane WA, 99207

Hours

5:30pm - 8:30pm Wednesday

We will be closed this week (6/30/2021) due to extreme heat.

Thank you for attending only if you ...

  • can wear a face mask/face shield (for those not fully vaccinated)
  • follow other health/sanitary regulations (six-foot distancing, handwashing, etc.),
  • do not have a fever, have not tested positive for Covid- 19 within the last 14 days or are not otherwise ill.

Thanks for supporting your
community 501(c)(3) makerspace


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Learning G-Code
12-23-2015, 10:03 AM,
#1
Learning G-Code
CNC Cookbook has a PDF that walks you through learning G-Code. I thought some might find it useful.

I haven't read through the whole thing, but CNC Cookbook is usually pretty good in their work. There are frequent references to their product(s) through the document, but from what I've read thus far, it's pretty good.

The Link!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)