Location

840 E Spokane Falls Blvd Bay #1 Spokane WA, 99202

Hours

5:30pm - 8:30pm Wednesday
New? Stop by for a tour at 6:30pm on Wednesdays

Thanks for supporting your
community 501(c)(3) makerspace


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
3d printer
06-17-2016, 01:14 PM,
#1
3d printer
What is a prefer nominal gap between a heated nozzle and the build plate pad
for a 3d printer?
Reply
06-18-2016, 09:53 AM,
#2
RE: 3d printer
When heated to operating temperature, the gap should be the same as your first layer height (roughly 0.05mm to 0.2mm). Generally, you need to have a way to adjust your Z-endstop to very close and then use software configuration to fine tune it.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)