Please visit the homepage for location and information on open hours |
Thread Rating:
3d printer
|
06-17-2016, 01:14 PM,
|
|||
|
|||
3d printer
What is a prefer nominal gap between a heated nozzle and the build plate pad
for a 3d printer? |
|||
06-18-2016, 09:53 AM,
|
|||
|
|||
RE: 3d printer
When heated to operating temperature, the gap should be the same as your first layer height (roughly 0.05mm to 0.2mm). Generally, you need to have a way to adjust your Z-endstop to very close and then use software configuration to fine tune it.
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)