Please visit the homepage for location and information on open hours |
Thread Rating:
Laser progress
|
11-30-2016, 11:20 AM,
|
|||
|
|||
RE: Laser progress
Hey Arthur, yes it is finally coming along. Once I figured out the LinuxCNC was the hard way, we changed over to what you have with Aruindo, GSheild and GRBL. A much easier solution and with a plugin through Inkscape to do the gcode it is working well, Any suggestions on a gcode sender? Using UGS mainly and Bcnc in the works but wonder if there is anything else out there, especially easy for the Linux box control.
John Woj
IdeaMakers Designs, LLC "I'm on the the verge of something" Breaking Bad |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Laser progress - by IdeaMakers - 11-26-2016, 05:33 PM
RE: Laser progress - by n8cutler - 11-26-2016, 05:47 PM
RE: Laser progress - by Dan - 11-27-2016, 10:43 AM
RE: Laser progress - by ABearden - 11-29-2016, 01:20 AM
RE: Laser progress - by IdeaMakers - 11-30-2016, 11:20 AM
RE: Laser progress - by ABearden - 11-30-2016, 11:14 PM
RE: Laser progress - by IdeaMakers - 12-01-2016, 11:35 AM
|
Users browsing this thread: 1 Guest(s)