Please visit the homepage for location and information on open hours |
Thread Rating:
Benchtop CNC Milling Machine (on hold)
|
04-21-2014, 08:46 AM,
|
|||
|
|||
RE: Benchtop CNC Milling Machine (on hold)
(04-17-2014, 10:46 PM)Brian_H Wrote: I had a similarly sized cnc benchtop mill years back, a Taig. Hey that's what I have! I use a gecko G540 4 axis controller with Kelling 282/oz steppers and I also run EMC2 (re-branded linuxcnc now). I have been very impressed with the quality of it it. I set it up to jog back and forth and can reliably hit .001, these are the second set of steppers because the first set were just not powerful enough and would stall as Brian mentioned. but I haven't had any problems now that I have the more powerful steppers and a good quality power supply.
-Dan
"If you didn't build it, you will never own it." - Barton Dring |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Benchtop CNC Milling Machine (on hold) - by Brian_H - 02-02-2013, 07:12 AM
RE: Benchtop CNC Milling Machine - by Pete - 03-11-2013, 10:19 AM
RE: Benchtop CNC Milling Machine - by Justin Bell - 03-15-2013, 06:53 PM
RE: Benchtop CNC Milling Machine (on hold) - by n8cutler - 04-16-2014, 08:14 PM
RE: Benchtop CNC Milling Machine (on hold) - by Brian_H - 04-17-2014, 10:46 PM
RE: Benchtop CNC Milling Machine (on hold) - by Dan - 04-21-2014, 08:46 AM
RE: Benchtop CNC Milling Machine (on hold) - by n8cutler - 04-22-2014, 08:27 PM
|
Users browsing this thread: 1 Guest(s)