Please visit the homepage for location and information on open hours |
Thread Rating:
3d printer
|
06-18-2016, 09:53 AM,
|
|||
|
|||
RE: 3d printer
When heated to operating temperature, the gap should be the same as your first layer height (roughly 0.05mm to 0.2mm). Generally, you need to have a way to adjust your Z-endstop to very close and then use software configuration to fine tune it.
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
3d printer - by thuan.huynh - 06-17-2016, 01:14 PM
RE: 3d printer - by ABearden - 06-18-2016, 09:53 AM
|
Users browsing this thread: 1 Guest(s)